Uw mand
Dpa 3506A
- Lees recensies (0)
- Gerelateerde accessoires
- Vergelijkbare producten
- Gratis bezorging
- Gegarandeerd lage prijzen
- Tevreden of terugbetaald
- 3 jaar garantie
Op dit moment niet beschikbaar
neem contact op met ons
Voorraad in de winkel
Niet verkrijgbaar in de winkel
INFORMEER MIJ OVER HAAR BINNENKOMST OP VOORRAAD
Ik wil per e-mail op de hoogte worden gehouden
Go
Het merk Dpa
Leer meer over het merk Dpa en ontdek de volledige catalogus.
Het grootste netwerk van winkels in Frankrijk
Vind alle informatie over onze superstores en onze gespecialiseerde boetieks.
Neem contact op met een deskundige
Onze muzikanten en enthousiaste teleconsulenten staan ??klaar om al je vragen te beantwoorden.
Microfoon set
d:dicate™ 3506A Stereo Kit with 4006A Omnidirectional is a complete stereo kit with two carefully factory-matched phantom powered omnidirectional condenser microphones.
Even though the standard tolerances on our d:dicate™ series are extremely low, a stereo match is even closer. These specially selected d:dicate™ 4006A microphones are matched within ±0.5 dB on both frequency response and sensitivity.
For reference stereo recording, there is no better choice than a d:dicate™ 4006A Microphone. These omnidirectional condenser microphones are linear and true in character. They come as a hand-matched pair that offers the truest capture of stereo sound available.
Even though the standard tolerances on our d:dicate™ series are extremely low, a stereo match is even closer. These specially selected d:dicate™ 4006A microphones are matched within ±0.5 dB on both frequency response and sensitivity.
For reference stereo recording, there is no better choice than a d:dicate™ 4006A Microphone. These omnidirectional condenser microphones are linear and true in character. They come as a hand-matched pair that offers the truest capture of stereo sound available.
Lire la suite
Technisch papier
- Handmicrofoon Nee
- Directional pattern: Omnidirectional
- Principle of operation: Pressure
- Cartridge type: Pre-polarized condenser
- Frequency range: 10 Hz - 20 kHz
- Frequency range, ±2 dB: 10 Hz - 20 kHz
- Sensitivity, nominal, ±2 dB at 250 Hz: 40 mV/Pa; -28 dB re. 1 V/Pa
- Equivalent noise level, A-weighted:Typ. 15 dB(A) re. 20 µPa (max. 17 dB(A))
- -Equivalent noise level, A-weighted: Typ. 27 dB (max. 29 dB)
- S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 79 dB(A)
- Total harmonic distortion (THD): < 1% up to 139 dB SPL peak
- Dynamic range: Typ. 124 dB
- Max. SPL, peak before clipping: 146 dB
- Switchable attenuator, filters etc.: 0 dB / -20 dB
- Output impedance: 200 Ω
- Minimum load impedance: 2 kΩ
- Cable drive capability: 100 m (328 ft)
- Output balance principle: Impedance balancing with Active Drive
- Common mode rejection ratio (CMRR): > 60 dB
- Power supply (for full performance): 48 V Phantom power (± 4 V)
- Current consumption: 2.8 mA
- Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Meer specificaties
Minder specificaties
